#Diy ink blotter how to#

This makes it useful for absorbing psychoactive chemicals so that they can be transported easily.īibulous paper is also used in chemistry labs to help absorb any excess liquid or moisture from the lens of a microscope or from the area that’s being observed.

It is generally made using a specific type of paper that is highly absorbent.

Depending on the concentration of LSD used in the dipping solution, each blotter will have a different dose of LSD.īlotter paper is also known as bibulous paper. The paper can then be divided into squares or strips. This allows the LSD to absorb into the blotter paper.

As you can see, this was a rather quick and less-than-careful job just to see if the material would work, and what I could learn from it.An LSD blotter is essentially a piece of paper with a dose of LSD in it.īlotter sheets are made by soaking the paper in a solution of LSD. Here's the back with the cork backing and the label of what map it came from. Here's the front with the too-small corners that need to be more contrasting. Thoughts on any of this? Perhaps I'll make a full-size prototype at 17 and another at 14 and see what I think. But 14' seems a little narrow for desk pad. The golden mean ratio would set up a dimension of 14'x22'. That works out to be a good size because most of the maps are 24' across, and with margin to fold over the board 22' works well. I'm also thinking of a size about 17' x 22', or a little over 43.18 cm x 55.88. I'm also thinking of adding some good sheets of loose paper tucked into the corners as a blotting surface. Cork back or felt? With he cork I can glue on the name of the USGS map this is cut from. I'm also going to use this one at work as a writing surface just to see how well it holds together.Īnyway. I already knew I'd need a bigger size for a desk, but something close to this size might make a nice writing surface you can take with you and use in cafes, the airport, etc. Cover the corners in a complimentary, solid-color material, maybe a micro-suede or some such fabric that would match the map.ģ. So, today I actually had a couple of hours as it was too hot to go outside, so I tackled a small prototype model of this project.Īnd the reason you do a prototype is because you learn things.Ģ. However you want, this at least gave me a pretty good idea of how I can make my own desk blotter/desk pad. I'm also wondering about possibly using sheet cork on the bottom instead of felt. I think I'm going to try this but instead of maps on the side bands, I think I'll try and use some scrap leather I have. Then I found the following crafty site that made it clearer just what you're trying to achieve. Most were not terribly helpful or ended up with something I didn't particularly like.

#Diy ink blotter how to#

I also started to find instruction on how to make your own desk pad. I started looking at possibly turning a stack of maps into a pad on an existing desk pad, similar to the calendar you often find on modern desk pads. So, I've been looking at ways to possibly turn a map or two into a desk blotter. It turns out you can't even give them away terribly easily. We've been trying to figure out just what to do with these cool, but not out-of-date maps. My wife and I inherited a very large stack (about 2.5 feet high) of unfolded US Geological Survey topographical maps from the 50's-70's from her late father who was a mining engineer.